Python Remote Not Locking Doors

I used the remote start almost daily without any issue.

Python remote not locking doors.

In december i had a remote start installed in my truck and am using the original truck key fobs to start the truck. Even if you forget to arm the system passive arming will protect the vehicle from would be thieves. If lock unlock does work please proceed to the next troubleshooting step. When placed in this mode the security system will arm itself 30 seconds after the customer leaves the vehicle.

When you press these buttons the parking lights should flash two times. If your remote has usb port plug it into a usb charger and then try again later. Try reprogramming your remotes. Check the remote antenna inside of your vehicle.

Also the vehicle would not shut off when i took the key out of the ignition had to repeat it to get the car to shut off. Your remote might also have lost programming. The problems started when i went to use the remote starter afew weeks ago and the alarm went off and i had to shut it off by starting the car with the key. Then the daylight running headlights would not work or the keyless entry.

Step 1 sit in the driver s seat and close all of the doors. If you own one of the high end compustar remotes that have internal batteries then it needs to be charged. Python remote starter wont start the vehicle doors will not unlock with the remote or start the car but will arm the alarm. If it unlocks the door the problem may be a weak battery in the key fob or a problem in the keyless entry antenna or wiring.

Python s remote start system allows users to operate their power locks and start their vehicle with the simple push of a button. Make sure that the connecting harness is fully secured. These should be going to a blue green wire lock and a yellow red wire unlock in the driver side kickpanel. Try holding the fob right next to the door handle when pressing the unlock button.

This feature can be used in conjunction with power door locks and windows to fully secure the vehicle. Sometimes after the battery in the car or remote start fob has been changed the fob won t work until it has been reset. The key fob itself could be defective or have a bad unlock button. Try the lock button trunk release button or panic button.

Most of our remote starters go into valet mode by pressing a combination of two buttons on the remote control for 1 2 second. If the remote is not responding to you there is a good possibility you just need a battery for it. Its hard to do with it working but you want to try to find the small gauge want to say 16 or 18 blue and green wires coming off the alarm brain. The fob would not lock or unlock the doors.

Check your connections there.