Fixing a clock that runs too fast can be as easy as turning a screw.
Pendulum wall clock runs slow.
Push the bob up to make the clock run faster and push the bob down to make it slower.
They are cheap and.
Moving a clock to a higher elevation will slow it down as the air is thinner.
The pendulum disk is moved up or down by turning the adjustment nut.
Changing the speed of time keeping is accomplished by moving the pendulum disk up or down.
Locate the adjustable weight or screw mechanism near the pendulum arm.
If the clock is running slow turn the pendulum nut clockwise to increase the rate.
Shorten the pendulum by turning the screw mechanism to the right 1 2 turn.
A clock that runs quickly still works fine.
Lengthen the pendulum by turning the screw mechanism to the left 1 2 turn.
To slow down the clock loosen the adjustment nut turn it toward your left.
A pendulum too high causes the clock to run fast.
Clocks with an interior or exterior pendulum have adjustment screws either on the pendulum or through a hole in the top of the clock.
The clock will run slower.
You may be able to replace the escape wheel with one that has fewer teeth which will require a longer pendulum.
Pendulum bob with rate adjustment french time and strike.
Adjust the bob at the bottom of the pendulum if the clock is running too fast or slow.
It may take up to two weeks to properly set a clock that runs fast.
Increasing the ambient temperature of a clock will slow it down from the expansion and lengthening of the pendulum unless the pendulum is a compensating type.
Too low causes the clock to run slow.
Denser air causes the pendulum to move more slowly.
If the clock is running fast turn the pendulum nut counterclockwise to decrease the rate.
It just needs a simple adjustment.
The movement that s in the clock also does not appear to be a very strung runner rather weak pendulum swing.
Adjust the pendulum up or down.
If it does not have a little slt that has and s and f on each side then it can not be adjusted go to walmart or a hobby shop and buy a new closck mechanism.
To slow the grandfather clock down move the pendulum disk down by turning the adjustment nut to the left.
Use the following rules to adjust the pendulum nut.