The only part that these two have in common is the master switch.
Passenger side door locks not working.
All times tested i could walk to the passenger side and it would work no issue.
The solenoid is bad.
If any wiring is damaged replace them.
2005 2010 hummer h3.
Isn t that a contradiction in terms.
If one door doesn t work but others do the problem could be a blown fuse.
Replacing it may require removing the car door panel.
Upon discovering this i tried to lock and unlock the doors from the passengers side lock switch the passengers side stops working too when the drivers door is open.
When a door ceases to lock and unlock at the press of a button it often means that the door s lock actuator has given up the ghost.
A fuse is blown.
The lock actuator consists of a small electric motor that drives.
If the result of this does not yield any results continue to step 2.
The most likely cause of your problem is the master switch in the drivers door.
Follow lead wire to the door lock actuator.
It s either the driver s side or the passenger s side.
The windows and the locks are on two separate circuits.
Later on they worked 50 of the time you tried.
Pop the window and door lock switch panel off the door handle.
Replacing the fuse will correct the problem.
Unplug the door lock connectors and inspect to make sure nothing stands out.
So yesterday my driver side door handle sensors for lock and unlock stopped working.
Of course it is also possible that the wiring harness between the driver side door and cowl is.
And it is the front door right.
I could walk around to the passenger side and they worked just fine.
Again if one door doesn t work but others do the problem could be with the door lock solenoid.
Also the door locks don t work when the drivers door is open.
Remove switch panel and inspect wiring.
You said drivers side passenger door lock.
Once i open the door more than a quarter of the way the locks stop responding.
If it s not sending a signal the fob will likely have to be replaced.